กลับไปที่บล็อก
คู่มือวิธีใช้ 2026-11-04 Groomer's Warehouse 0 การดู

How to Use Artero Matt-X Dematter on Matted Coats Safely

How to Use Artero Matt-X Dematter on Matted Coats Safely

Learn a step-by-step process for using Artero Matt-X Dematter to loosen mats safely, plus a matt splitter technique and checkpoints that prevent coat damage.

Quick answer

Apply Artero Matt-X Dematter sparingly to the mat, work it in with your fingers, then split the mat with a matt splitter before combing from the tip inward. Stop immediately if you feel skin or resistance that does not release.

Why a leave-in dematting spray changes the job

Artero Matt-X Dematter is a leave-in spray with anti-static benefits that helps remove tangles and knots while leaving a smooth, silky finish without sticky residue. That matters because dry mats grip tighter and create more friction as you work. A light application reduces that friction so your splitter and comb glide instead of tug.

The trade-off is that spray alone does not dissolve a tight mat. It softens the surface and reduces static, but the mat still needs mechanical splitting. Groomers who expect a spray to melt a mat often over-apply product and then comb too hard, which is where skin irritation happens.

When not to demat in the salon

Skip dematting and clip the coat instead when the mat is felted tight against the skin, when the dog flinches or snaps at the touch, or when you cannot slide a comb between the mat and the skin. Matt-X Dematter is a surface conditioner, not a substitute for clipper work on a pelted coat.

Also avoid using the spray near the eyes, inside the ears, or on broken skin. The catalog does not list a full ingredient breakdown, so if a dog has a known sensitivity, patch test on a small area and wait before treating the whole coat.

Step-by-step: safe mat removal with Matt-X Dematter

  1. Check the mat against the skin: Part the coat and try to slide a fine comb between the mat and the skin. If the comb will not pass, do not spray and pull; clip the coat instead. Common mistake: assuming every mat can be saved. If the comb stops, stop the dematting plan.
  2. Apply Matt-X Dematter sparingly: Mist the mat lightly from about 6–8 inches, aiming at the mat rather than the whole dog. Work it in with your fingertips so the product reaches the knot. Common mistake: soaking the coat, which makes the hair slippery and harder to control. Light and targeted beats wet and heavy.
  3. Split the mat with a matt splitter: Hold the mat between two fingers to protect the skin, then insert the matt splitter at the outer edge and make small vertical cuts through the center of the mat. Never cut horizontally across the skin. Common mistake: forcing the splitter through in one pass. Split the mat into smaller sections before combing.
  4. Comb from the tip inward: Use a comb or slicker to work from the outer tip of the loosened hair toward the skin in short strokes. Reapply a light mist only if the hair feels dry and resistant. Common mistake: starting at the skin and pulling the whole mat at once. Work in small sections, not one big pull.
  5. Check the skin and stop if needed: After each section, lift the hair and look for redness, broken skin, or a dog that is tense. If you see any of these, stop and switch to clipping. Common mistake: continuing because the mat is almost out. Skin condition overrides finishing the mat.

Product facts

  • Artero Matt-X Dematter: Artero Matt-X Dematter is a leave-in dematting spray that creates an anti-static effect and leaves no sticky residue. You can work it into the coat without rinsing, and the anti-static effect helps the comb pass through loosened hair instead of re-tangling it.
    Artero Matt-X Dematter
    Artero Matt-X Dematter

บทความที่เกี่ยวข้อง

Customer Service
หน้าแรก
สินค้า
ตะกร้า
โปรไฟล์